ASTM E 1602 : 2003
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Guide for Construction of Solid Fuel Burning Masonry Heaters
Hardcopy , PDF
11-11-2014
English
01-10-2003
Important note : Users cannot be edited or removed once added to your Multi user PDF.CONTAINED IN VOL. 04.11, 2017 Defines the design and construction of solid fuel burning masonry heaters.
| Committee |
E 06
|
| DocumentType |
Guide
|
| Pages |
9
|
| ProductNote |
Reconfirmed 2003
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1 This guide covers the design and construction of solid fuel burning masonry heaters. It provides dimensions for site constructed masonry heater components and clearances that have been derived by experience and found to be consistent with the safe installation of those masonry heaters.
1.2 Values given in SI units are to be regarded as standard. Inch/pound units may be rounded (see IEEE/ASTM SI-10). All dimensions are nominal unless specifically stated otherwise. All clearances listed in this guide are actual dimensions.
1.3 This guide applies to the design and construction of masonry heaters built on-site with the components and materials specified herein. It does not apply to the construction/installation requirements for component systems that have been safety tested and listed. The requirements for listed masonry heater systems are specified in the manufacturer's installation instructions.
1.4 The design and construction of solid fuel burning masonry heaters shall comply with applicable building codes.
| ASTM E 2778 : 2014 | Standard Specification for Custom Tiled/Mortared Masonry Heaters (Stoves) |
| ASTM E 2817 : 2011 : R2018 | Standard Test Method for Test Fueling Masonry Heaters |
| UL 103:11ED 2010-10-15 | Factory-Built Chimneys for Residential Type and Building Heating Appliances |
| IEEE/ASTM SI_10-2010 | American National Standard for Metric Practice |
| ASTM E 136 : 2016-02 | TEST METHOD FOR BEHAVIOUR OF MATERIALS IN A VERTICAL TUBE FURNACE AT 750 DEGREES C |
| ASTM C 11 : 2017-06 | TERMINOLOGY RELATING TO GYPSUM AND RELATED BUILDING MATERIALS AND SYSTEMS |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.