ASTM E 1925 : 2001
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Specifiction for Engineering and Design Criteria for Rigid Wall Relocatable Structures
Hardcopy , PDF
11-11-2014
English
10-04-2001
Important note : Users cannot be edited or removed once added to your Multi user PDF.| Committee |
E 06
|
| DocumentType |
Standard
|
| Pages |
12
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1 This specification covers engineering and design criteria required for the development of rigid wall relocatable structures (RWRS) and shall be applied to the design of expandable and non-expandable RWRSs. This specification applies to present engineering and design requirements for effective RWRSs which are operable in a variety of environments without degradation and are capable of all specified transport modes. This specification shall be applied to the design of expandable and non-expandable RWRSs. This specification is a conversion of a military standard that was approved by all departments and agencies of the Department of Defense.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parenthesis are for information only.
1.3 The following safety hazards caveat pertains only to the test required portion, Section 10, of this specification. This specification does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this specification to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM E 1978 : 2018 | Standard Specification for Shelter, Tactical, Expandable, Two-Side |
| ASTM E 631 : 2015 | Standard Terminology of Building Constructions |
| ASTM E 1975 : 2018 | Standard Specification for Shelter, Electrical, Equipment S-280/G |
| ASTM E 2517 : 2013 | Standard Specification for Cargo Bed Cover, Type III (M35A2, 2 1/2 Ton Cargo Truck/M1078, 2 1/2 Ton Lightweight Medium Tactical Vehicle (LMTV)/ M1082, 2 1/2 Ton LMTV Trailer) |
| ASTM E 1749 : 2018 | Standard Terminology Relating to Rigid Wall Relocatable Shelters |
| ASTM E 2377 : 2018 | Standard Specification for Shelter, Electrical Equipment, Lightweight |
| ASTM E 1977 : 2018 | Standard Specification for Shelter, Tactical, Expandable, One-Side |
| ASTM E 2462 : 2018 | Standard Performance Specification for Cargo Bed Cover (CBC) HMMWV, Type I |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.