ASTM E 2129 : 2018

1.2 This practice is organized according to the Construction Specifications Institute’s (CSI) MasterFormat2 sections to promote consistency in the evaluation of building products.1.2.1 CSI MasterFormat version 1995 is used to organize information in Table 2. Appendix X1 provides a cross reference comparison to CSI MasterFormat 2004.(A) For additional information, visit http://www.epa.gov/tri.(B) NTP (National Toxicology Program). 2016. Report on Carcinogens, Fourteenth Edition.; Research Triangle Park, NC: U.S. Department of Health and Human Services, Public Health Service. https://ntp.niehs.nih.gov/go/roc14.(C) The term “ENERGY STAR” and the ENERGY STAR logo are trademarks of the U.S. Environmental Protection Agency (EPA).(D) Additional information may be obtained from U.S. Department of Energy, Office of Energy Efficiency & Renewable Energy, Forrestal Bldg. 1000 Independence Ave., SW, Washington, DC 20585, https://www.energy.gov/eere/femp/federal-energy-management-program.(E) Note that some of the questions under Criterion No. 1 (Materials [Product Feedstock]) refer to attributes of products, for example, toxicity, that pose concerns for indoor environmental quality as well. In the interest of avoiding repetition, those questions are not repeated here. Respondents are reminded to answer all questions in the general section of this questionnaire.1.3 This practice includes general, comprehensive data requirements. Depending upon the building product, certain data requirements may not apply given the unique characteristics of the product and the potential environmental impacts related to the intended use of the product. Depending upon the building product, certain data requirements may need to be added as appropriate to the unique characteristics of the product and the potential environmental impacts related to the intended use of the product.1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.