ASTM E 2831/E2831M : 2011
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Guide for Deployment of Blast Resistant Trash Receptacles in Crowded Places
Hardcopy , PDF
11-11-2014
English
01-07-2011
CONTAINED IN VOL. 15.08, 2018 Classifies the key factors that should be considered prior to the deployment of blast resistant trash receptacles (BRTRs) in crowded places.
Committee |
E 54
|
DocumentType |
Guide
|
Pages |
5
|
ProductNote |
Reconfirmed 2011
|
PublisherName |
American Society for Testing and Materials
|
Status |
Superseded
|
SupersededBy |
1.1 This guide identifies the key factors that should be considered prior to the deployment of blast resistant trash receptacles (BRTRs) in crowded places.
1.1.1 Guidance is included for their deployment at interior and exterior locations associated with the crowded places.
1.2 Facilities and venues where blast resistant trash receptacles may be deployed include, but are not limited to:
1.2.1 Airports,
1.2.2 Banks and other financial institutions,
1.2.3 Bars and nightclubs,
1.2.4 Convention centers,
1.2.5 Entertainment and event centers,
1.2.6 Hotels,
1.2.7 Health care locations,
1.2.8 Museums,
1.2.9 Places of worship,
1.2.10 Public government locations including fire and police stations,
1.2.11 Railway stations, bus stations, and related transit areas,
1.2.12 Restaurants,
1.2.13 Retail centers and malls,
1.2.14 Schools, universities, and related areas used for education,
1.2.15 Stadiums and arenas, and
1.2.16 Theaters.
1.3 Guidance on conducting a threat assessment or vulnerability analysis, and on responding to incidents associated with the deployment of blast resistant trash receptacles is beyond the scope of this document.
1.4 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM D 790 : 2017 : REDLINE | Standard Test Methods for Flexural Properties of Unreinforced and Reinforced Plastics and Electrical Insulating Materials |
ASTM D 638 : 2014 : REDLINE | Standard Test Method for Tensile Properties of Plastics |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.