ASTM E 3142 : 2018
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for Thermal Lag of Thermal Analysis Apparatus
Hardcopy , PDF
13-07-2023
English
15-01-2018
CONTAINED IN VOL. 14.05, 2018 Defines the dependence of temperature calibration on the temperature rate-of-change.
Committee |
E 37
|
DocumentType |
Test Method
|
Pages |
3
|
PublisherName |
American Society for Testing and Materials
|
Status |
Superseded
|
SupersededBy |
1.1This test method addresses the dependence of temperature calibration on the temperature rate-of-change. This test method describes the determination of the thermal lag of thermal analysis apparatus and its application to the modification of the temperature calibration for that apparatus obtained at alternative linear temperature rates-of-change.
1.2This test method is applicable, but not limited to, the temperature calibration of differential thermal analyzers (DTAs), differential scanning calorimeters (DSCs), thermogravimetric analyzers (TGAs), thermomechanical analyzers (TMAs), and dynamic mechanical analyzers (DMAs).
1.3The values stated in SI units are to be regarded as the standard. No other units of measurement are included in this standard.
1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM E 1867 : 2018 | Standard Test Methods for Temperature Calibration of Dynamic Mechanical Analyzers |
ASTM E 1363 : 2018 | Standard Test Method for Temperature Calibration of Thermomechanical Analyzers |
ASTM E 1970 : 2016 : REDLINE | Standard Practice for Statistical Treatment of Thermoanalytical Data |
ASTM E 1142 : 2015 : REDLINE | Standard Terminology Relating to Thermophysical Properties |
ASTM E 1582 : 2017 : REDLINE | Standard Test Method for Temperature Calibration of Thermogravimetric Analyzers |
ASTM E 473 : 2016-05 | TERMINOLOGY RELATING TO THERMAL ANALYSIS AND RHEOLOGY |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.
Logging out.