ASTM E 3331 : 2022 : REV A

1.1This test method describes the procedure to determine the target modulus (or deflection) required for compaction quality control of geomaterials using light weight deflectometer (LWD) drops on a compacted proctor mold in the laboratory.2

1.2The same LWD type in terms of brand name, buffer stiffness, and deflection measurement location (on top of the plate or on top of the soil layer) used for the laboratory target modulus testing must be used during the field testing. This is to eliminate differences between measurements from different devices.

1.3This procedure shall be performed in the laboratory on representative soil samples before the field compaction operations.

1.4Gradation, moisture content inconsistency, and surface texture on the mold can affect the material moduli results.

1.5The target surface modulus values can be compared to the field-measured modulus for compaction quality control/quality assurance purposes.

1.6This test method covers the determination of the relationship between moisture content and modulus of unbound granular material using the light weight deflectometer (LWD) on laboratory compaction samples.

1.7Units—The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. The values given in parentheses are for information only.

1.8This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.9This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.