ASTM E 3453/E3453M : 2024
Current
The latest, up-to-date edition.
Standard Specification for Ballistic-Resistant Body Armor Accessories
01-10-2024
| Committee |
E 54
|
| DocumentType |
Standard
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Current
|
1.1This specification specifies minimum performance requirements and test methods for the ballistic resistance of body armor accessories used by U.S. public safety officers and intended to protect areas of the body (for example, shoulder, neck, groin, pelvis, lower abdomen, lower back, lower sides, and limbs) not covered by traditional body armor.
1.1.1This specification addresses accessories that cover a single area of the body (for example, shoulder protector) and accessories that cover multiple areas of the body (for example, body armor cummerbund).
1.2This specification addresses ballistic performance in terms of resistance to penetration (RTP).
1.3This specification does not address upper torso side protection.
Note 1:Upper torso side protection will be addressed in another standard because backface deformation (BFD) measurements for side protection are required to meet the same performance requirements as body armor.
1.4This specification is applicable for compliance testing, verification testing, certification testing, or research and development testing.
1.5This specification is divided into the following sections:
| Section | Title |
| 1 | Scope |
| 2 | Referenced Documents |
| 3 | Terminology |
| 4 | Significance and Use |
| 5 | Test Equipment and Materials |
| 6 | Test Item Requirements |
| 7 | Procedure for Visual Examination |
| 8 | Resistance to Penetration (RTP) Ballistic Protection Levels and Test Threats |
| 9 | Shot Requirements |
| 10 | Soft Armor Accessory RTP Requirement and Test Procedure |
| 11 | Hard Armor Accessory RTP Requirement and Test Procedure |
| 12 | Product Documentation Requirements |
| 13 | Product Label and Package Label Requirements |
| 14 | Test Report |
| 15 | Keywords |
| Annex A1 | ASTM Accessory RTP Ballistic Protection Levels and Associated Test Threats |
| Annex A2 | Ballistic Accessories Testing Summary |
1.6Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.7This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.8This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| ASTM E 3192/E3192M : 2020 : R2026 | Standard Practice for Soft Armor Conditioning by Tumbling |
| ASTM E 3192/E3192M : 2020 | Standard Practice for Soft Armor Conditioning by Tumbling |