ASTM E 570 : 2015 : EDT 1

1.1This practice covers the application and standardization of equipment using the flux leakage test method for detection of outer surface, inner surface, and subsurface discontinuities in ferromagnetic steel tubular products (Note 1) of uniform cross section such as seamless and welded tubing.

1.2This practice is intended for use on tubular products having outside diameters from approximately ¹/₂to 24 in. (12.7 to 610 mm) with wall thicknesses to ¹/₂in. (12.7 mm). These techniques have been used for other sizes, however, and may be so specified upon contractual agreement between the purchaser and the supplier.

1.3This practice does not establish acceptance criteria; they must be specified by the using parties.

1.4The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.5This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.