ASTM F 1488 : 2026

1.1ÂThis specification covers coextruded composite pipe, intended for non-pressure gravity flow drain waste or vent (DWV) service, or plastic underdrain service, or electrical or comunications conduit service produced by a coextrusion die system, in which the concentric layers are formed and combined before exiting the die.

1.2ÂCompounds that do not meet the requirements of the material section are excluded.

1.3ÂThe coextruded composite pipe is allowed to be perforated in accordance with any specified standard or by agreement between the purchaser and the supplier.

1.4ÂThe coextruded composite pipe is allowed to be belled for joining by solvent cementing or belled for joining by an elastomeric seal (gaskets), in accordance with any specified standard or by agreement between the purchaser and the supplier.

1.5ÂRecommendations for storage, joining, installation, and rationale are listed in Appendix X1, Appendix X2, Appendix X3, and Appendix X4, respectively.

1.6ÂThe values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.

1.7ÂThe text of this specification references notes, footnotes, and appendixes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of this specification.

1.8ÂThis standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.9ÂThis international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.