ASTM F 2414 : 2004

CONTAINED IN VOL. 04.12, 2016 Describes proposed selection of materials, installation techniques, and inspection required for sealing manholes using chemical grout.

1.1 This practice covers proposed selection of materials, installation techniques, and inspection required for sealing manholes using chemical grout. Manholes or sections of manholes with active leaks shall be repaired. Manholes to be grouted are of brick, block, cast-in-place concrete, precast concrete, or fiberglass construction. Manholes or sections of manholes with active leaks will be designated by the engineer, owners representative, or authorized inspector, for manhole grouting.

1.2 The contractor shall be responsible for furnishing all labor, supervision, materials, equipment, and inspection follow-up required for the completion of chemical grouting of manhole defects in accordance with the contract documents.

1.3 Materials, additives, mixture ratios, and procedures utilized for the grouting process shall be in accordance with manufacturers recommendations and shall be appropriate for the application.

1.4 The values stated in inch/pound units are to be regarded as the standard. The values in parentheses are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.