ASTM F 2465/F2465M : 2005 : R2016
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Guide for Oil Spill Dispersant Application Equipment: Single-point Spray Systems
Hardcopy , PDF
10-06-2020
English
01-02-2016
CONTAINED IN VOL. 11.04, 2012 Defines performance criteria, requirements, material characteristics, and essential features for oil spill dispersant application systems.
Committee |
F 20
|
DevelopmentNote |
Supersedes ASTM F 2465. (11/2011)
|
DocumentType |
Guide
|
Pages |
4
|
ProductNote |
Reconfirmed 2016
|
PublisherName |
American Society for Testing and Materials
|
Status |
Superseded
|
SupersededBy | |
Supersedes |
1.1This guide covers performance criteria, requirements, material characteristics, and essential features for oil spill dispersant application systems. This guide is not intended to be restrictive to a specific configuration.
1.2This guide covers vessel-based spray systems employing single-point spray nozzles, including designs that have been based on or evolved from “fire-monitor” systems, and is not fully applicable to other systems such as spray boom/nozzle or aircraft systems.
1.3This guide is one of five related to dispersant application systems. The other four guides cover the design of boom and nozzle systems, spray system calibration, spray deposition measurements, and use of the systems. Familiarity with all five guides (listed in 2.1) is recommended.
1.4The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM F 1737 : 1996 : R1999 | Standard Guide for Use of Oil Spill Dispersant Application Equipment During Spill Response: Boom and Nozzle Systems |
ASTM F 1738 : 2015 | Standard Test Method for Determination of Deposition of Aerially Applied Oil Spill Dispersants |
ASTM F 1738 : 2019 | Standard Test Method for Determination of Deposition of Aerially Applied Oil Spill Dispersants |
ASTM F 1738 : 1996 : R1999 | Standard Test Method for Determination of Deposition of Aerially Applied Oil Spill Dispersants |
ASTM F 1737 : 2007 | Standard Guide for Use of Oil Spill Dispersant Application Equipment During Spill Response: Boom and Nozzle Systems |
ASTM F 1738 : 2015 : REDLINE | Standard Test Method for Determination of Deposition of Aerially Applied Oil Spill Dispersants |
ASTM F 1738 : 1996 : R2007 | Standard Test Method for Determination of Deposition of Aerially Applied Oil Spill Dispersants |
ASTM F 1738 : 2010 | Standard Test Method for Determination of Deposition of Aerially Applied Oil Spill Dispersants |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.