ASTM F 2729 : 2012
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Consumer Safety Specification for Constant Air Inflatable Play Devices for Home Use
Hardcopy , PDF
11-04-2019
English
01-09-2012
Important note : Users cannot be edited or removed once added to your Multi user PDF.CONTAINED IN VOL. 15.11, 2015 Determines performance requirements, test methods, and labeling requirements to promote the safe use of constant air inflatable play devices for private home use.
| Committee |
F 15
|
| DocumentType |
Standard
|
| Pages |
19
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy |
1.1This consumer safety specification establishes performance requirements, test methods, and labeling requirements to promote the safe use of constant air inflatable play devices for private home use. Constant air inflatable play devices for home use that incorporate water play features and do not retain water are not considered as portable pools. Constant air inflatable play devices for home use that incorporate water play features and are intended to hold water for wading or water recreational purposes are applicable to the marking and labeling section of this specification. This specification does not apply to stored air inflatable swimming pools or sealed inflatable devices whether or not they retain water.
1.2This consumer safety specification provides safety requirements for various types of constant air inflatable play devices for home use intended for children aged from two (2) years through twelve (12) years.
1.3This consumer safety specification is intended to reduce the risk of death and minimize serious injury to children resulting from use of constant air inflatable play devices for home use.
1.4No constant air inflatable play devices for home use produced after the approval date of this consumer safety specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements contained herein. The following statement is suggested for use in identifying a product that conforms to all requirements in this specification:
1.5The test values and dimensions stated in SI units are to be regarded as standard. The inch-pound values in parenthesis, when given, are for information only.
1.6General Measures, Tolerances, and Conversions:
1.6.1The general tolerances for this specification (unless otherwise specified) are as follows:
Dimension Tolerance
X ± 12.7 mm (X ± 0.5 in.)
X.X ± 1.27 mm (X.X ± 0.05 in.)
X.XX ± 0.127 mm (X.XX ± 0.005 in.)
These tolerances still apply to a dimension even when terms like greater than, less than, minimum, or maximum are used.
1.7The following precautionary caveat pertains only to the test methods portion of this consumer safety specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM F 2374 : 2019 | Standard Practice for Design, Manufacture, Operation, and Maintenance of Inflatable Amusement Devices |
| ASTM F 2374 : 2018-02 | PRACTICE FOR DESIGN, MANUFACTURE, OPERATION, AND MAINTENANCE OF INFLATABLE AMUSEMENT DEVICES |
| CFR 16(PTS1000-END) : 0 | COMMERCIAL PRACTICES - FEDERAL TRADE COMMISSION - CONSUMER PRODUCT SAFETY COMMISSION |
| ASTM F 963 : 2017 : REDLINE | Standard Consumer Safety Specification for Toy Safety |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.