ASTM F 2861 : 2020
Current
The latest, up-to-date edition.
Standard Test Method for Enhanced Performance of Combination Oven in Various Modes
Hardcopy , PDF
English
01-10-2020
Important note : Users cannot be edited or removed once added to your Multi user PDF.| Committee |
F 26
|
| DocumentType |
Test Method
|
| Pages |
19
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Current
|
| Supersedes |
1.1This test method covers the evaluation of the energy and water consumption and the cooking performance of combination ovens that can be operated in hot air convection, steam, and the combination of both hot air convection and steam modes. The test method is also applicable to convection ovens with moisture injection. The results of this test method can be used to evaluate a combination oven and understand its energy consumption.
1.2This test method is applicable to gas and electric combination ovens that can be operated in convection, steam and combination modes.
1.3The combination oven can be evaluated with respect to the following (where applicable):
1.3.1Energy input rate and thermostat calibration (10.2).
1.3.2Preheat energy consumption and time (10.3).
1.3.3Idle energy rate in convection, steam and combination modes (10.4).
1.3.4Pilot energy rate (if applicable) (10.5).
1.3.5Cooking-energy efficiency, cooking energy rate, production capacity, water consumption and condensate temperature in steam mode (Appendix X1) (10.6).
1.3.6Cooking-energy efficiency, cooking energy rate, and production capacity in convection mode (10.7).
1.3.7Cooking uniformity in combination mode (X1.3).
1.4The values stated in inch-pound units are to be regarded as standard. The SI units given in parentheses are for information only.
1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| ASTM D 3588 : 1998 : R2017 : EDT 1 | Standard Practice for Calculating Heat Value, Compressibility Factor, and Relative Density of Gaseous Fuels |
| ASTM D 3588 : 1998 : R2024 : EDT 1 | Standard Practice for Calculating Heat Value, Compressibility Factor, and Relative Density of Gaseous Fuels |
| ASTM F 1217 : 2017 : R2023 | Standard Specification for Cooker, Steam |
| ASTM F 1217 : 2017 | Standard Specification for Cooker, Steam |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.