ASTM F 3023 : 2018

1.1 These test methods specify procedures and equipmentused for testing and evaluating stationary exercise upright andrecumbent bicycles and ergometers for compliance to SpecificationF1250. Both design and operational parameters will beevaluated. Where possible and applicable, accepted test methodsfrom other recognized bodies will be used and referenced.In the case of a conflict between this document and SpecificationF1250, Specification F1250 takes precedence.1.2 Requirements—Stationary exercise bicycles and ergometersare to be tested for the parameters specified in SpecificationF2276 and Test Methods F2571 and the followingparameters unique to this equipment:1.2.1 Seat post construction and loading,1.2.2 Handlebar construction and loading,1.2.3 Pedal construction and loading,1.2.4 Crank arm and enclosure entrapment,1.2.5 Seat back support loading,1.2.6 Stability,1.2.7 Direct Drive Exercise Bicycle Pedal Endurance,1.2.8 Warnings, and1.2.9 Documentation.1.3 This test method2 contains additional requirements toaddress the accessibility of the equipment for persons withdisabilities.1.4 Units—The values stated in SI units are to be regardedas standard. The values given in parentheses are mathematicalconversions to inch-pound units that are provided for informationonly and are not considered standard.1.5 This standard does not purport to address all of thesafety concerns, if any, associated with its use. It is theresponsibility of the user of this standard to establish appropriatesafety, health, and environmental practices and determinethe applicability of regulatory limitations prior to use.1.6 This international standard was developed in accordancewith internationally recognized principles on standardizationestablished in the Decision on Principles for theDevelopment of International Standards, Guides and Recommendationsissued by the World Trade Organization TechnicalBarriers to Trade (TBT) Committee.