ASTM F 3060 : 2020

1.1This terminology contains a listing of terms, abbreviations, acronyms, and symbols related to aircraft covered by ASTM Committees F37 and F44 airworthiness design standards. It is intended to ensure the consistent use of terminology throughout all ASTM light aircraft standards.

1.2Units—The definitions of units will be as defined in NIST SP 330 and will not be duplicated in this document. NIST SP 330 is available on the internet. The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.3Source References—The listed document(s) was/were the original source for the definition. However, the definition may have been edited for use in this document and the F37 and F44 standards, and may not completely match the original in every respect.

1.4A definition adapted from a particular standard within the ASTM aircraft collection of standards is not limited to use within only those standards.

1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.