ASTM F 3103 : 2014 : R2019

1.1This specification covers performance requirements for helmets used by off-road motorcycle and All-Terrain Vehicle (ATV) riders.

1.2Compliance with the federally mandated FMVSS No. 218 shall be documented as part of compliance with this ASTM standard.

1.3This specification provides additional performance requirements including positional stability and performance criteria for chin bars on full-facial coverage helmets if the helmet is equipped with a chin bar.

1.4This standard does not require that helmets provide full facial coverage.

1.5This is a performance specification and is not intended to restrict design.

1.6All testing and requirements of this specification shall be in accordance with Test Methods F1446, except where noted herein.

1.7Partial utilization of this standard is prohibited. Any statement of compliance with this specification must be a certification that the product meets all of the requirements of this specification in its entirety. A product that fails to meet any one of the requirements of this specification is considered to have failed this standard, and should not be sold with any indication that it meets parts of this standard.

1.8Headgear designed to comply with this and other standards may proclaim uses as certified by the manufacturer.

1.9The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.10The following safety caveat applies to the chemical, mechanical, or physical, or a combination thereof, test methods described herein and is meant specifically for those performing the tests (in an effort to provide them with notice to take the appropriate precautions when conducting the tests): This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.11This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.