ASTM F 3637 : 2023

1.1In this standard, guidelines for measuring post-manufacturing relative density of metallic additive manufactured (AM) parts and density assessment test specimens are given.

1.2In this guide, standard test methods commonly used to measure part relative density and details any procedural changes or recommendations for use with PBF-LB parts are referenced. Extensibility to other types of metallic AM processes may be considered on a case-by-case basis with user discretion.

1.3This guide is intended to be applied during the selection process of methods to measure the relative density of AM parts to balance cost, accuracy, complexity, part destruction, and part size concerns.

1.4Pore size, shape, and distribution and their implications relative to the AM process and material are beyond the scope of this guide; however, each method’s ability to obtain these metrics is discussed in the context of the various density measurement methods.

1.5Units—The values stated in SI units are to be regarded as the standard. No other units of measurement are included in this standard.

1.6This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.