ASTM F 436/F436M : 2018
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Specification for Hardened Steel Washers Inch and Metric Dimensions
Hardcopy , PDF
14-09-2018
English
01-06-2018
Important note : Users cannot be edited or removed once added to your Multi user PDF.1.1This specification covers the chemical, mechanical, and dimensional requirements for hardened steel washers for use with fasteners having nominal thread diameters of1/4through 4 in. and M12 through M100.
| Committee |
F 16
|
| DocumentType |
Standard
|
| Pages |
8
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This specification covers the chemical, mechanical, and dimensional requirements for hardened steel washers for use with fasteners having nominal thread diameters of 1/4through 4 in. and M12 through M100. These washers are intended for general-purpose mechanical and structural use with bolts, nuts, studs, and other internally and externally threaded fasteners. These washers are suitable for use with fasteners covered in Specifications A354, A449, A563, A563M, F959/F959M, and F3125.
1.2The washers are designated by type denoting the material, by style denoting the shape, and by inch or metric dimensions.
1.2.1The types of washers covered are:
1.2.1.1Type 1—Carbon steel.
1.2.1.2Type 3—Weathering steel.
1.2.1.3This specification provides for furnishing Type 3 to chemical composition or a Corrosion Index (CRI) of 6 or higher at the suppliers option.
1.2.2The styles of washers covered are:
1.2.2.1Circular—Circular washers in nominal bolt sizes 1/4through 4 in. and M12 through M100 suitable for applications where sufficient space exists and angularity permits.
1.2.2.2Beveled—Beveled washers are square or rectangular, in nominal sizes 1/2through 11/2in., M12 through M16, with a beveled 1 to 6 ratio surface for use with American standard beams and channels.
1.2.2.3Clipped—Clipped washers are circular or beveled for use where space limitations necessitate that one side be clipped.
1.2.2.4Extra Thick—Extra thick washers are circular washers in nominal sizes 1/2through 4 in., with a nominal thickness of 5/16in. suitable for structural applications with oversized holes.
1.3Terms used in this specification are defined in Terminology F1789 unless otherwise defined herein.
1.4The values stated in either inch-pound units for inch fasteners and SI units for metric fasteners and are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.