ASTM F 708 : 1992 : R1997
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Practice for Design and Installation of Rigid Pipe Hangers
Hardcopy , PDF
11-11-2014
English
10-04-1997
Important note : Users cannot be edited or removed once added to your Multi user PDF.CONTAINED IN VOL. 01.07, 2018 Defines acceptable methods of fabricating and installing rigid pipe hangers used to support shipboard piping systems with temperatures of 650 degrees F (343 degrees C) or less.
| Committee |
F 25
|
| DocumentType |
Standard Practice
|
| Pages |
13
|
| ProductNote |
Reconfirmed 1997
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy |
1.1 This practice covers acceptable methods of fabricating and installing rigid pipe hangers used to support shipboard piping systems with temperatures of 650°F (343°C) or less.
1.2 This practice provides guidance for the design of hanger caps, straps and standoffs, selection of hanger and hanger liner materials, hanger bolting, and hanger spacing.
1.3 Other hanger designs may be used provided they result in an adequately supported vibration free piping system and are compatible with the intended system service and temperature limitations.
1.4 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.