ASTM F 799 : 2025 : REDLINE

1.1This specification covers requirements of cobalt-28 chromium-6 molybdenum alloy (UNS R31537, R31538, R31539) high-strength forgings for the manufacture of surgical implants. The properties specified in this document specifically apply to finished or semi-finished parts that receive no subsequent thermomechanical processing.

1.2Wrought material to be used as forging stock in the manufacture of forgings conforming to this specification, typically hot-worked and unannealed with a surface finish suitable for forging, shall be fabricated and supplied in accordance with Specification F1537.

1.3Units—The SI units in this standard are the primary units. The values stated in either primary SI units or secondary inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.4Any agreement between purchaser and supplier must meet the minimum requirements of this specification.

1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.