ASTM F 912 : 2011
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Specification for Alloy Steel Socket Set Screws
Hardcopy , PDF
23-11-2023
English
01-11-2011
Important note : Users cannot be edited or removed once added to your Multi user PDF.CONTAINED IN VOL. 01.09, 2018 Defines the requirements for quenched and tempered alloy steel socket-set screws (SSS) 0.060 through 2.000 in. sizes having hardnesses 45 to 53 HRC.
| Committee |
F 16
|
| DocumentType |
Standard
|
| Pages |
4
|
| ProductNote |
Reconfirmed 2011
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1 This specification covers the requirements for quenched and tempered alloy steel socket-set screws (SSS) 0.060 through 2.000-in. sizes having hardnesses 45 to 53 HRC.
1.2 These set screws are intended for compression applications only and are not customarily subjected to embrittlement tests. For tensile applications, consult with the manufacturer for proper alloy and hardness.
1.3 The hazard statement pertains only to the test method section, Section 11 of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1—A complete metric companion to Specification F 912 has been developed—F 912M; therefore, no metric equivalents are shown in this Specification.
| ASTM F 606/F606M : 2016 : REDLINE | Standard Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, Direct Tension Indicators, and Rivets |
| ASTM F 788 : 2013-04 | SPECIFICATION FOR SURFACE DISCONTINUITIES OF BOLTS, SCREWS, AND STUDS, INCH AND METRIC SERIES |
| ASTM E 384 : 2017 : REDLINE | Standard Test Method for Microindentation Hardness of Materials |
| ASTM F 2328 : 2017 : REDLINE | Standard Test Method for Determining Decarburization and Carburization in Hardened and Tempered Threaded Steel Bolts, Screws, Studs, and Nuts |
| ASME B18.3 : 2012 | SOCKET CAP, SHOULDER, SET SCREWS, AND HEX KEYS (INCH SERIES) |
| ASME B18.24 : 2015 | PART IDENTIFYING NUMBER (PIN) CODE SYSTEM STANDARD FOR B18 FASTENER PRODUCTS |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.