ASTM G 2/G2M : 2006 : R2011 : EDT 1
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for Corrosion Testing of Products of Zirconium, Hafnium, and Their Alloys in Water at 680°F (360°C) or in Steam at 750°F (400°C)
Hardcopy , PDF
28-02-2019
English
01-09-2011
Important note : Users cannot be edited or removed once added to your Multi user PDF.CONTAINED IN VOL. 03.02, 2015 Defines 1) the determination of mass gain, and 2) the surface inspection of products of zirconium, hafnium, and their alloys when corrosion tested in water at 680 degrees F [360 degrees C] or in steam at 750 degrees F [400 degrees C].
| Committee |
B 10
|
| DevelopmentNote |
Supersedes ASTM G 2 (03/2006)
|
| DocumentType |
Test Method
|
| Pages |
8
|
| ProductNote |
Reconfirmed EDT 1
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This test method covers (1) the determination of mass gain, and (2) the surface inspection of products of zirconium, hafnium, and their alloys when corrosion tested in water at 680°F [360°C] or in steam at 750°F [400°C].
1.2This test method is to be utilized in its entirety to the extent specified herein as a product acceptance test.
1.3This test method may be used on wrought products, castings, powder metallurgy products, and weld metals.
1.4Unless a single unit is used, for example corrosion mass gain in mg/dm2, the values stated in either inch-pound or SI units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore each system must be used independently of the other. SI values cannot be mixed with inch-pound values.
1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see Section 9.
| ASTM D 888 : 2012-05 | TEST METHODS FOR DISSOLVED OXYGEN IN WATER |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.