ASTM G 94 : 2005
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Guide for Evaluating Metals for Oxygen Service
Hardcopy , PDF
11-11-2014
English
01-09-2005
CONTAINED IN VOL. 14.04, 2015 Pertains to metallic materials under consideration for oxygen or oxygen-enriched fluid service, direct or indirect.
Committee |
G 04
|
DocumentType |
Guide
|
Pages |
31
|
ProductNote |
Reconfirmed 2005
|
PublisherName |
American Society for Testing and Materials
|
Status |
Superseded
|
SupersededBy | |
Supersedes |
1.1 This guide applies to metallic materials under consideration for oxygen or oxygen-enriched fluid service, direct or indirect, as defined in Section . It is concerned primarily with the properties of a metallic material associated with its relative susceptibility to ignition and propagation of combustion. It does not involve mechanical properties, potential toxicity, outgassing, reactions between various materials in the system, functional reliability, or performance characteristics such as aging, shredding, or sloughing of particles, except when these might contribute to an ignition.
1.2 This document applies only to metals; nonmetals are covered in Guide G 63.
Note 1The American Society for Testing and Materials takes no position respecting the validity of any evaluation methods asserted in connection with any item mentioned in this guide. Users of this guide are expressly advised that determination of the validity of any such evaluation methods and data and the risk of use of such evaluation methods and data are entirely their own responsibility.
Note 2In evaluating materials, any mixture with oxygen exceeding atmospheric concentration at pressures higher than atmospheric should be evaluated from the hazard point of view for possible significant increase in material combustibility.
1.3 The values stated in SI units are to be regarded as the standard.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM G 88 : 2013 : REDLINE | Standard Guide for Designing Systems for Oxygen Service |
CGA P 8.4 : 2013 | SAFE OPERATION OF REBOILERS/CONDENSERS IN AIR SEPARATION UNITS |
ASTM G 72 : 2001 | Standard Test Method for Autogenous Ignition Temperature of Liquids and Solids in a High-Pressure Oxygen-Enriched Environment |
CGA G 4.8 : 2013 | SAFE USE OF ALUMINUM-STRUCTURED PACKING FOR OXYGEN DISTILLATION |
ASTM D 2512 : 2017 | Standard Test Method for Compatibility of Materials with Liquid Oxygen (Impact Sensitivity Threshold and Pass-Fail Techniques) (Withdrawn 2023) |
ASTM G 86 : 1998 : REV A | Standard Test Method for Determining Ignition Sensitivity of Materials to Mechanical Impact in Ambient Liquid Oxygen and Pressurized Liquid and Gaseous Oxygen Environments |
ASTM G 63 : 2015 : REDLINE | Standard Guide for Evaluating Nonmetallic Materials for Oxygen Service |
CGA G 4.4 : 2012 | OXYGEN PIPELINE AND PIPING SYSTEMS |
ASTM G 126 : 2016 : REDLINE | Standard Terminology Relating to the Compatibility and Sensitivity of Materials in Oxygen Enriched Atmospheres |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.