BS 1202-3:1974

Co-operating organizations
Foreword
Specification
1 Scope
2 Materials
3 Workmanship
4 Finish
5 Dimensions and tolerances
6 Inspection
7 Weights
8 Designation for ordering
9 Certificate of compliance
Tables
1 Dimensions and approximate count of round plain head
    nails
2 Dimensions and approximate count of round lost head
    nails
3 Dimensions and approximate count of clout, slate and
    tile nails
4 Dimensions and approximate count of extra large head
    felt nails
5 Dimensions and approximate count of nipple head
    roofing nails
6 Dimensions and approximate count of panel pins
7 Dimensions and approximate count of gimp pins
8 Dimensions and approximate count of tile pegs
9 Dimensions and approximate count of annular ringed
    shank flat head nails
10 Dimensions and approximate count of helical threaded
    shank flat head nails

Materials, manufacture. Dimensions, tolerances, weights. Designation for ordering. Tables and figures for 10 types of wire nail.

1.1 This Part of this British Standard specifies requirements, including dimensions and finish for the following types of aluminium nails.

NOTE. The nearest former s.w.g. numbers are included in a separate column in each table for convenience only. They do not form part of the specification.

1. Round plain head nails
2. Round lost head nails
3. Clout, slate and tile nails
4. Extra large head felt nails
5. Nipple head roofing nails
6. Panel pins
7. Gimp pins
8. Tile pegs, sharp and round point
9. Annular ring shank flat head nails
10. Helical threaded shank flat head nails

1.2 The types of nail are illustrated in the diagrams accompanying Tables 1 to 10.

NOTE. The title of the British Standard referred to in this standard is given on the inside back cover.