BS 1449-1.1:1991
Current
The latest, up-to-date edition.
Steel plate, sheet and strip. Carbon and carbon-manganese plate, sheet and strip General specification
Hardcopy , PDF
English
31-10-1991
Committees responsible
Foreword
Specification
0 Introduction
1. Scope
2. Definitions
3. General
4. Steelmaking process
5. Chemical composition
6. Freedom from defects
7. Condition of material on delivery
8. Number of tests
9. Tensile properties
10. Bending
11. Strain-age-embrittlement
12. Stabilization
13. Formability
14. Hardness
15. Decarburization test
16. Retests
17. Surface finish and surface inspection
18. Edge conditions
19. Inspection
21. Marking
Appendices
A. Product analysis and permitted variations
B. Methods of test
C. Determination of r values
Tables
1. Symbols for material conditions
2. Symbols for surface finishes and surface inspection
3. Summary of material grades, chemical compositions
and types of steel available
4. Edge conditions
5. Permitted variations of product analysis from
specified range. Applicable to killed (K) steels
only
Figures
1. Bend test with the axis of the bend parallel to the
direction of rolling
2. Bend test with the axis of the bend at 90 deg to
the direction of rolling
3. Nomogram for determination of r values
Gives general requirements for flat rolled carbon steel products, available in the hot or cold rolled conditions and in coil or cut length form, rolled as wide strip in widths less than 600 mm. Covers plate, sheet and strip in thicknesses up to 16 mm and the material grades, chemical compositions and types of steel. Covers steelmaking process, condition of material on delivery, tensile properties, strain age embrittlement, stabilization, formability, hardness and decarburization test.
| Committee |
ISE/109
|
| DevelopmentNote |
Together with BS 1449-1.2(1991), BS 1449-1.3(1991), BS 1449-1.4(1991), BS 1449-1.5(1991), BS 1449-1.6(1991), BS 1449-1.7(1991), BS 1449-1.8(1991), BS 1449-1.9(1991), BS 1449-1.10(1991), BS 1449-1.11(1991), BS 1449-1.12(1991), BS 1449-1.13(1991), BS 1449-1.14(1991), BS 1449-1.15(1991), and BS EN 10130 it supersedes BS 1449-1(1983). (05/2006) Reviewed and confirmed by BSI, January 2010. (12/2009)
|
| DocumentType |
Standard
|
| Pages |
20
|
| PublisherName |
British Standards Institution
|
| Status |
Current
|
| Supersedes |
This Section of BS1449 specifies general requirements for flat rolled carbon steel products, available in the hot or cold rolled conditions and in coil or cut length form, rolled as wide strip in nominal widths of 600mm and wider or as narrow strip in nominal widths less than 600mm, as specified in BS1449‑1.2 to BS1449‑1.15.
This Section of BS1449 covers plate, sheet and strip in nominal thicknesses up to and including 16mm and the material grades, chemical compositions and types of steel summarized in Table3.
NOTE The titles of the publications referred to in this standard are listed on page 16.
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : Users cannot be edited or removed once added to your Multi user PDF.