BS 1643:2008
Current
The latest, up-to-date edition.
Specification for precision vernier height gauges
Hardcopy , PDF
English
31-08-2009
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Construction
5 Scales
6 Accuracy of reading
7 Protection
Annexes
Annex A (normative) - Methods of test
Bibliography
Describes requirements for the construction, accuracy at the reference temperature of 20 degree C and the protection of metric and imperial precision vernier height gauges which include a scriber for marking heights.
Committee |
TPR/1
|
DevelopmentNote |
Supersedes BS 1643(1983) and 08/30178093 DC. (11/2008) Earlier was replaced in error, now has been reinstated as current/partially replaced by BSI. (10/2015)
|
DocumentType |
Standard
|
Pages |
18
|
PublisherName |
British Standards Institution
|
Status |
Current
|
SupersededBy |
This British Standard specifies requirements for the construction, accuracy at the reference temperature of 20 °C and the protection of metric and imperial precision vernier height gauges which include a scriber for marking heights. The metric height gauges measure height up to a maximum of 1 000 mm using a main scale and vernier scale graduated to read to 0.02 mm. The imperial height gauges measure height up to a maximum of 48 in using a main scale and vernier scale graduated to read to 0.001 in.
NOTE 1 Attention is drawn to the fact that the metric dimensions are not necessarily direct conversions of the imperial dimensions. For instance, the vernier division of 0.02 mm marked on the metric height gauge corresponds to a 0.001 in vernier division on the imperial height gauge, whereas the actual conversion is 0.001 in = 0.0254 mm.
Requirements for setting blocks which might be supplied are also specified.
Methods of testing height gauges are specified in Annex A.
BS 2795:1981 | Specification for dial test indicators (lever type) for linear measurement |
BS EN ISO 3650:1999 | Geometrical product specifications (GPS). Length standards. Gauge blocks |
PREN ISO 13225-1 : DRAFT 2008 | GEOMETRICAL PRODUCT SPECIFICATIONS (GPS) - DIMENSIONAL MEASURING INSTRUMENTS; HEIGHT GAUGES - PART 1: SIMPLE HEIGHT GAUGES; DESIGN AND METROLOGICAL CHARACTERISTICS |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.