BS 2782-10:Method 1002:1977
Current
The latest, up-to-date edition.
Methods of testing plastics. Glass reinforced plastics Determination of loss on ignition
Hardcopy , PDF
English
31-08-1977
Important note : Users cannot be edited or removed once added to your Multi user PDF.
Cooperating organizations
Brief history
Foreword
1 Scope
2 Principle of the method
3 Apparatus
4 Sampling and test specimens
5 Conditioning of test specimens
6 Procedure
7 Calculation and expression of results
8 Test report
National appendix A - Origins of work and
relationship with other
British Standards
Defines a method for determining the loss on ignition of glass reinforced plastics.
| Committee |
PRI/21
|
| DevelopmentNote |
Also numbered as EN 60. Supersedes 74/74599 DC. (06/2005)
|
| DocumentType |
Standard
|
| Pages |
10
|
| PublisherName |
British Standards Institution
|
| Status |
Current
|
This standard describes a method for determining the loss on ignition of glass reinforced plastics.
1.1 If the material to be tested contains only glass and a resin which is completely combustible (under the conditions of this test method), the loss on ignition is equal to the resin content (see note below). The glass content may then be calculated by difference.
1.2 In the case of products which contain non-combustible mineral fillers, other than glass reinforcement, or resins which are incompletely combustible (under the conditions of this test method), the presence of which materials can be recognized or verified by examination of the residue after ignition, this method only allows the determination of the ash by difference.
NOTE The glass used as a reinforcement is usually coated with ancillary products (sizing, finish, etc.) which most often are completely eliminated during calcination and therefore included in the loss on ignition.
| Standards | Relationship |
| UNE-EN 502:2013 | Identical |
| NFT 57 102 : 1977 | Identical |
| BS 5480-2:1982 | Specification for glass fibre reinforced plastics (GRP) pipes and fittings for use for water supply or sewerage Design and performance requirements |
| DEFSTAN 93-111/1(2004) : 2004 | FIBRE REINFORCED POLYMER COMPOSITE FOR BALLISTIC PROTECTION PURPOSES |
| BS 7008-1:1988 | Acquisition and presentation of comparable data for basic properties of plastics. Method for single-point data |
| BS 4549-1:1997 | Guide to quality control requirements for reinforced plastics mouldings Guide to the preparation of a scheme to control the quality of glass reinforced polyester mouldings |
| BS 3749:1991 | Specification for E glass fibre woven roving fabrics for the reinforcement of polyester and epoxy resins systems |
| BS 4994:1987 | Specification for design and construction of vessels and tanks in reinforced plastics |
| BS 6464:1984 | Specification for reinforced plastics pipes, fittings and joints for process plants |
| DEFSTAN 02-701(PT3)/1(2000) : 2000 | GLASS REINFORCED PLASTIC (GRP) MOULDINGS - PART 3: A GUIDE TO THE VARIOUS TESTS AND TESTING METHODS FOR EVALUATION OF THE QUALITY OF GRP MOULDINGS |
| BS 2782-4:Method 432A:1991 | Methods of testing plastics. Chemical properties Determination of residual styrene monomer content in reinforced plastics based on unsaturated polyester resins |
| BS 7159:1989 | Code of practice for design and construction of glass-reinforced plastics (GRP) piping systems for individual plants or sites |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.