BS 2782-3.352E(1996) : 1996 AMD 15287

Superseded

Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View superseded by

METHODS OF TESTING PLASTICS - MECHANICAL PROPERTIES - DETERMINATION OF IMPACT RESISTANCE BY THE FREE-FALLING DART METHOD (STAIRCASE METHOD)

Available format(s):

Superseded date: 13-09-2004

Language(s):

Published date: 23-11-2012

Publisher: British Standards Institution

Table of Contents - (Show below) - (Hide below)

Committees responsible
National foreword
Method
1 Scope
2 Normative references
3 Significance
4 Definitions
5 Apparatus
6 Test specimens
7 Conditioning and testing atmospheres
8 Procedure
9 Calculation
10 Test report
Figures
1 Apparatus for free-falling dart impact test
2 Calculation of impact failure mass by the staircase
procedure

Abstract - (Show below) - (Hide below)

Gives methods for determining the energy causing plastics film and sheet less than 1 mm thick to fail under specified conditions o impact of a free-falling dart from a specified height resulting in failure of 50% of the tested specimens.

General Product Information - (Show below) - (Hide below)

Committee	PRI/75
Development Note	Supersedes BS 2782-3.352D(1979) (07/2004) Renumbered and superseded by BS EN ISO 7765-1. (09/2004)
Document Type	Standard
ISBN
Pages
Published
Publisher	British Standards Institution
Status	Superseded
Superseded By	BS EN ISO 7765-1:2004
Supersedes	BS 2782-3 Method 352D:1979

International Equivalents – Equivalent Standard(s) & Relationship - (Show below) - (Hide below)

Equivalent Standard(s)	Relationship
ISO 7765-1:1988	Identical

Standards Referenced By This Book - (Show below) - (Hide below)

BS 2782-3:Method 352F:1996	Methods of testing plastics. Mechanical properties Determination of impact resistance by the free-falling dart method (instrumented puncture test)

Standards Referencing This Book - (Show below) - (Hide below)

ISO 4591:1992	Plastics — Film and sheeting — Determination of average thickness of a sample, and average thickness and yield of a roll, by gravimetric techniques (gravimetric thickness)
ISO 291:2008	Plastics Standard atmospheres for conditioning and testing
ISO 4593:1993	Plastics Film and sheeting Determination of thickness by mechanical scanning

Categories associated with this Standard - (Show below) - (Hide below)

Sub-Categories associated with this Standard - (Show below) - (Hide below)

Sorry this product is not available in your region.

Add To Cart