BS 2782-3.353B(1991) : 1991 AMD 8634
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
METHODS OF TESTING PLASTICS - MECHANICAL PROPERTIES - DETERMINATION OF MULTI-AXIAL IMPACT BEHAVIOUR BY THE INSTRUMENTED PUNCTURE TEST
15-06-1997
23-11-2012
National foreword
Committees responsible
Method
1 Scope
2 Normative references
3 Definitions
4 Principle
5 Apparatus
6 Test specimens
7 Procedure
8 Expression of results
9 Test report
Annexes
A Interpretation of complex force-deformation curves
B Derivation of the approximation for lp used in
clause 8
C General remarks
D Bibliography
Figures
1 Force-deformation diagram for tough materials
2 Force-deformation diagram for very tough materials
3 Force-deformation diagram for brittle materials
4 Test device
5 Clamping device
A.1 Force-deformation diagram for a UV-aged or strongly
oriented material
A.2 Force-deformation diagram for a brittle or fibre-
filled material
A.3 Force-deformation diagram in the case of strong
resonance
Provides a method for determining multiaxial impact behaviour of rigid plastics in the form of flat test specimen, such as discs and squares, moulded directly or cut from sheets. This test is used for the characterization of plastic sheeting or mouldings under the impact of a striker applied at a right angle to the plane of the sheet. Different test parameters are specified depending on the geometry of the striker. Covers normative references, definitions, principle, apparatus, test specimens, procedure, expression of results and test report. AMD 8634 RENUMBERS THIS STANDARD
| Committee |
PRM/21
|
| DevelopmentNote |
Renumbered and superseded by BS EN ISO 6603-2. (11/2005)
|
| DocumentType |
Standard
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| ISO 6603-2:2000 | Identical |
| BS 2782-3:Method 352F:1996 | Methods of testing plastics. Mechanical properties Determination of impact resistance by the free-falling dart method (instrumented puncture test) |
| BS 7825-3.3:1997 | Calibration of rubber and plastics test equipment. Calibration schedules Mechanical properties of plastics |
| ISO 293:2004 | Plastics — Compression moulding of test specimens of thermoplastic materials |
| ISO 294:1995 | Plastics Injection moulding of test specimens of thermoplastic materials |
| ISO 291:2008 | Plastics Standard atmospheres for conditioning and testing |
| ISO 7765-2:1994 | Plastics film and sheeting Determination of impact resistance by the free-falling dart method Part 2: Instrumented puncture test |
| ISO 2557-2:1986 | Plastics Amorphous thermoplastics Preparation of test specimens with a specified reversion Part 2: Plates |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.