BS 3G 100-2.3.12:1991
Current
The latest, up-to-date edition.
Specification for general requirements for equipment for use in aircraft. All equipment. Environmental conditions Fluid contamination
Hardcopy , PDF
English
31-05-1991
Important note : Users cannot be edited or removed once added to your Multi user PDF.
Foreword
Committees responsible
Specification
1. Scope
2. Test fluid
3. Test samples
4. Cleaning
5. Initial examination
6. Test procedures
7. Occasional contamination (class A)
8. Intermittent contamination (class B)
9. Extended contamination (class C)
10. Final examination
11. Information to be supplied in the product
specification
Appendix
A. Guidance on the choice of test fluids and test
materials
Table
1. Major contaminant fluid groups and test fluids
Tests to demonstrate that equipment (including materials, components or subassemblies) will not be unacceptably affected by contaminating fluids to which it may be exposed.
| Committee |
ACE/58
|
| DevelopmentNote |
Supersedes 89/78555 DC and BS 3G100-2.3.12(1986). (12/2003) Partially supersedes BS 2G100-2(1962). (07/2005) Reviewed and confirmed by BSI, November 2011. (10/2011)
|
| DocumentType |
Standard
|
| Pages |
12
|
| PublisherName |
British Standards Institution
|
| Status |
Current
|
This British Standard specifies tests to demonstrate that the equipment including materials, components or sub-assemblies (incorporating joints, welds or bonds) from which the equipment is constructed will not be unacceptably affected by contaminating fluids to which it or they may be exposed. It should be read in conjunction with British Standard 3G 100-0.
The fluids listed in this standard are representative of those commonly encountered in operational applications. Fluids not listed and for which a test is required should be included in the product specification.
These tests are not intended to demonstrate the suitability of an equipment or component to perform in continuous contact with a fluid, e.g. an immersed fuel pump. Nor are they a test to demonstrate immunity from electrolytic corrosion.
NOTE The titles of the publications referred to in this standard are listed on the inside back cover.
| BS 1595(1965) : LATEST | PROPAN-2-OL (ISOPROPYL ALCOHOL) FOR INDUSTRIAL USE |
| BS 3G 100-0:1980 | Specification for general requirements for electrical equipment and indicating instruments for aircraft Introduction |
| BS 4487:1969 | Specification for inhibited 1,1,1-trichloroethane (methylchloroform) |
| ISO 1817:2015 | Rubber, vulcanized or thermoplastic Determination of the effect of liquids |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.