BS 4300-4(1973) : 1973
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
WROUGHT ALUMINIUM AND ALUMINIUM ALLOYS FOR GENERAL ENGINEERING PURPOSES (SUPPLEMENTARY SERIES) - 6464 SOLID EXTRUDED BARS AND SECTIONS SUITABLE FOR BRIGHT TRIM/REFLECTOR APPLICATIONS
Hardcopy , PDF
15-06-2001
BS EN 573-3:2013
BS EN 755-6:2008
BS EN 573-4:2004
BS EN 755-2:2016
BS EN 515:2017
BS EN 755-5:2008
BS EN 755-3:2008
BS EN 755-9:2016
BS EN 755-1:2016
BS EN 755-4:2008
English
01-01-1973
Important note : Users cannot be edited or removed once added to your Multi user PDF.
Co-operating organizations
Foreword
Specification
1 General
1.1 Scope
1.2 Definitions
2 General requirements
2.1 General
2.2 Freedom from defects
2.3 Chemical composition
2.4 Condition
2.5 Sizes and tolerances
2.6 Selection of test samples
2.7 Mechanical tests
2.8 Retests
2.9 Certificate of compliance
2.10 Inspection
2.11 Independent test
2.12 Facilities for testing
2.13 The rounding of numbers rule
3 Specific requirements
3.1 Chemical composition
3.2 Mechanical properties
3.3 Tolerances
3.4 Normal radii for corners
Appendices
A Standard sizes of material
B Details of the international alloy designations
and chemical composition limits for wrought
aluminium alloys system
Tables
1 Heat-treatable materials; grouping into batches
2 Table deleted
3 Tensile test
4 Tolerances on diameter and length of round bar
intended for use on automatic lathes
5 Tolerances on width and diameter of bars and
regular sections
6 Tolerances on thickness of bars and regular
sections
7 Tolerances on open ends of channels and I-beams
8 Angular tolerances for extruded sections
9 Tolerances on length
10 Tolerances on straightness for extruded bar and
regular sections
11 Tolerances on twist for extruded sections
12 Normal radii for corners
Figure
1 Tolerances on open ends of channels and I-beams
Describes solid bars and sections of diameter or minor cross sectional dimension not exceeding 50mm in an aluminium alloy suitable for bright trim/reflector applications.
| Committee |
NFM/35
|
| DocumentType |
Standard
|
| Pages |
22
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy |
| BS 1474:1987 | Specification for wrought aluminium and aluminium alloys for general engineering purposes: bars, extruded round tubes and sections |
| BS 1615:1987 | Method for specifying anodic oxidation coatings on aluminium and its alloys |
| BS 2646-1:1993 | Autoclaves for sterilization in laboratories Specification for design, construction, safety and performance |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.