BS 4551:1980
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Methods of testing mortars, screeds and plasters
Hardcopy , PDF
15-02-1998
English
28-11-1980
Foreword
Cooperating organizations
Section one. General
0. Introduction
1. Scope
2. References
3. Definitions
4. Sampling
Section two. Chemical testing
5. Laboratory preparation of samples for chemical
analysis
6. Chemical analysis and aggregate grading
7. Calculation of mix proportions and interpretation
of results
Section three. Physical testing
8. Laboratory preparation of mortar mixes
9. Procedure for plant and site mixed mortars
10. Determination of consistence by dropping ball
11. Determination of consistence retentivity and water
retentivity
12. Determination of flow
13. Determination of air content of freshly mixed mortars
14. Determination of stiffening rate
15. Determination of strength
16. Determination of bulk density of hardened mortar or
plaster
17. Certificate of physical tests
Appendix A
Details of flow table
Tables
1. Available lime contents of nominal volume mixes
2. Equations for the calculation of composition of
freshly mixed or hardened mortars, screeds and
plasters
3. Composition of types of mortars, screeds and plasters
4. Guide to minimum quantity of materials required for
various tests
5. Percentages of fractions of standard sands
6. Composition of laboratory mixes
Figures
1. Typical mixer bowl and blade
2. Diagrammatic representation of ball release
3. Suitable device for measuring penetration
4. Apparatus for measurement of air content (pressure
method)
5. Flow table and conical mould
6. Determination of stiffening rate of mortar
7. Compression jig for 25 mm x 25 mm x 100 mm mortar
specimens
Methods of sampling, analysis, preparation and testing of mortars for bricklaying, screeding, plastering and rendering.
Committee |
B/519/2
|
DevelopmentNote |
BS DRAFT 94/107156 DC REFERS TO AMD 2
|
DocumentType |
Standard
|
Pages |
46
|
PublisherName |
British Standards Institution
|
Status |
Superseded
|
SupersededBy |
BS 6319-1:1983 | Testing of resin and polymer/cement compositions for use in construction Method for preparation of test specimens |
BS 5385-1:1995 | Wall and floor tiling Code of practice for the design and installation of internal ceramic and natural stone wall tiling and mosaics in normal conditions |
BS 8204-1:1999 | Screeds, bases and in-situ floorings Concrete bases and cement sand levelling screeds to receive floorings. Code of practice |
BS 5385-2:1991 | Wall and floor tiling Code of practice for the design and installation of external ceramic wall tiling and mosaics (including terra cotta and faience tiles) |
PD 6472:1974 | Guide to specifying the quality of building mortars |
BS 3892-1:1993 | Pulverized-fuel ash Specification for pulverized-fuel ash for use with Portland cement |
BS 3892-1:1997 | Pulverized-fuel ash Specification for pulverized-fuel ash for use with Portland cement |
BS 5080-1:1993 | Structural fixings in concrete and masonry Method of test for tensile loading |
BS 5628-1:1992 | Code of practice for use of masonry Structural use of unreinforced masonry |
BS 3921:1985 | Specification for clay bricks |
BS 5534-1:1997 | Code of practice for slating and tiling Design |
BS 5268-6.2(2001) : 2001 | STRUCTURAL USE OF TIMBER - PART 6: CODE OF PRACTICE FOR TIMBER FRAME WALLS - SECTION 6.2: BUILDINGS OTHER THAN DWELLINGS NOT EXCEEDING FOUR STOREYS |
DD ENV 1996-1.1 : DRAFT DEC 1996 | EUROCODE 6: DESIGN OF MASONRY STRUCTURES - GENERAL RULES FOR BUILDINGS - GENERAL RULES FOR BUILDINGS - RULES FOR REINFORCED AND UNREINFORCED MASONRY (TOGETHER WITH UNITED KINGDOM NATIONAL APPLICATION DOCUMENT) |
BS 5385-3:1989 | Wall and floor tiling Code of practice for the design and installation of ceramic floor tiles and mosaics |
BS 6073-1:1981 | Precast concrete masonry units Specification for precast concrete masonry units |
03/303957 DC : DRAFT APR 2003 | BS 5385 - WALL AND FLOOR TILING - PART 3: CODE OF PRACTICE FOR THE DESIGN AND INSTALLATION OF INTERNAL AND EXTERNAL CERAMIC FLOOR TILES AND MOSAICS IN NORMAL CONDITIONS |
I.S. 20-1:1987 | CONCRETE BUILDING BLOCKS - PART 1: NORMAL DENSITY BLOCKS |
BS 7542:1992 | Method of test for curing compounds for concrete |
03/308581 DC : DRAFT JULY 2003 | BS 5385-2 - WALL AND FLOOR TILING - PART 2: DESIGN AND INSTALLATION OF EXTERNAL CERAMIC WALL TILING AND MOSAICS IN NORMAL CONDITIONS - CODE OF PRACTICE |
BS 4887-2:1987 | Mortar admixtures Specification for set retarding admixtures |
BS 6463-103:1999 | Quicklime, hydrated lime and natural calcium carbonate Methods for physical testing |
BS 4887-1:1986 | Mortar admixtures Specification for air-entraining (plasticizing) admixtures |
BS 8221-2:2000 | Code of practice for cleaning and surface repair of buildings Surface repair of natural stones, brick and terracotta |
02/105033 DC : DRAFT AUG 2002 | BS 5534 - CODE OF PRACTICE FOR SLATING AND TILING (INCLUDING SHINGLES) |
BS 1902-11:1991 | Methods of testing refractory materials Refractory mortars and putties |
BS 1881-4(1970) : LATEST | |
BS 308-3:1972 | Engineering drawing practice. Geometrical tolerancing |
BS 891-1:1962 | Method for Rockwell hardness test Testing of metals |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.