BS 5892-2:1992

Committees responsible
Foreword
Specification
1. Scope
2. Definitions
3. Information to be supplied by the purchaser
4. Classification and heat treatment
5. Manufacture
6. Manufacturer's brand marks
7. Inspection
8. Type and number of tests
9. Test methods
10. Test results
11. Conclusion of inspection
12. Certification
13. Protection in transport
Tables
1. Chemical composition
2. Machining allowances and dimensional tolerances
3. Ready for assembly surface finishes and dimensions
4. Type and number of tests
5. Heat treatment condition and mechanical properties
Figures
1. Key to the symbols used in table 2
2. Oil injection hole
3. Position of brand marks on wheel centres
4. Position and direction within wheel centre rim of
     tensile test piece

Requirements for the manufacture, inspection and testing of centres in the machined, part machined or ready for assembly condition for tractive and trailing stock.

This Part of BS 5892 specifies requirements for the manufacture, inspection and testing of forged and/or rolled wheel centres in the unmachined, part machined or ready for assembly condition for traction and trailing stock. This Part of BS 5892 includes requirements for the dimensions, tolerances, and surface finish that are to be adopted unless otherwise specified in the design drawing.

NOTE The titles of the publications referred to in this Part of BS 5892 are listed on the inside back cover.