BS 5911-3:2010+A1:2014

BS 5911-3 was prepared to complement BS EN 1917:2002.

BSEN1917 specifies requirements and describes test methods for precast concrete manholes of circular and rectangular (with or without chamfered or rounded corners) or elliptical cross-section, unreinforced, steel fibre and reinforced, with nominal sizes or nominal lengths not exceeding DN 1250 or LN 1250, respectively. The intended use of BSEN1917 is to permit access to, and to allow aeration of, drain or sewer systems for the conveyance of sewage, rainwater and surface water under gravity or occasionally at low head of pressure, mainly installed in areas subjected to vehicular and/or pedestrian traffic. This part of BS5911 specifies complementary requirements to those in BSEN1917 for unreinforced and reinforced concrete manholes of circular and rectangular cross-section (with or without chamfered or rounded corners), as provided for in BSEN1917, i.e. units with nominal sizes or nominal lengths not exceeding DN 1250 or LN 1250, respectively. Full requirements for unreinforced and reinforced circular concrete manholes with nominal sizes greater than DN 1250, but not exceeding DN 3000, are also specified. The manholes are intended to be installed in carriageways of roads (including pedestrian streets), hard shoulders and parking areas for all types of road vehicles, though provision is also made for units subject to lighter traffic loading. Requirements for base units, elastomeric load bearing seals, soakaways, landing slabs and corbel slabs are also specified. NOTE1 Rectangular manholes greater than LN 1250 are to be treated as structures and should be accompanied by appropriate calculations in accordance with the relevant Eurocodes. NOTE2 BSEN752 , BSEN1295 ‑1 and BSEN1610 relate to the planning, design, installation and testing of drains and sewers.