BS 6043-4.9:1991
Withdrawn
A Withdrawn Standard is one, which is removed from sale, and its unique number can no longer be used. The Standard can be withdrawn and not replaced, or it can be withdrawn and replaced by a Standard with a different number.
Methods of sampling and test for carbonaceous materials used in aluminium manufacture. Cold ramming pastes Determination of the cold crushing strength of baked rammed paste
Hardcopy , PDF
22-06-2023
English
30-09-1991
Important note : Users cannot be edited or removed once added to your Multi user PDF.
Committees responsible
Foreword
Method
1. Scope
2. Principle
3. Apparatus
4. Materials
5. Sampling
6. Preparation of test samples
7. Procedure
8. Calculation and expression of results
9. Test report
Figure
1. Typical ancillary adaptor for compression testing
machine
Method employing compression testing equipment.
| Committee |
W/-
|
| DevelopmentNote |
Supersedes 90/54849 DC (09/2005) Reviewed and confirmed by BSI, November 2008. (11/2008)
|
| DocumentType |
Standard
|
| Pages |
8
|
| PublisherName |
British Standards Institution
|
| Status |
Withdrawn
|
This Section of BS 6043 describes a method for the determination of the cold crushing strength of baked rammed cold ramming pastes used in aluminium manufacture.
NOTE The titles of the publications referred to in this standard are listed on the inside back cover.
| BS 6043-4.13:1991 | Methods of sampling and test for carbonaceous materials used in aluminium manufacture. Cold ramming pastes Determination of ash of baked rammed paste |
| BS 6043-4.7:1991 | Methods of sampling and test for carbonaceous materials used in aluminium manufacture. Cold ramming pastes Preparation of baked rammed test pieces and determination of baked apparent density, change in volume and loss in mass |
| BS 6043-4.10:1991 | Methods of sampling and test for carbonaceous materials used in aluminium manufacture. Cold ramming pastes Determination of the apparent porosity of baked rammed paste |
| BS 6043-4.0:1991 | Methods of sampling and test for carbonaceous materials used in aluminium manufacture. Cold ramming pastes General introduction |
| BS 6043-4.0:1991 | Methods of sampling and test for carbonaceous materials used in aluminium manufacture. Cold ramming pastes General introduction |
| BS 6043-4.1:1991 | Methods of sampling and test for carbonaceous materials used in aluminium manufacture. Cold ramming pastes Methods of sampling |
| BS 1902-4.3:1985 | Methods of testing refractory materials. Properties measured under an applied stress Determination of cold crushing strength of dense shaped products (method 1902-403) |
| BS 6043-4.6:1991 | Methods of sampling and test for carbonaceous materials used in aluminium manufacture. Cold ramming pastes Determination of maximum rammed apparent density of unbaked paste |
| BS 6043-4.7:1991 | Methods of sampling and test for carbonaceous materials used in aluminium manufacture. Cold ramming pastes Preparation of baked rammed test pieces and determination of baked apparent density, change in volume and loss in mass |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.