BS 6076:1996

Committees responsible
Foreword
Introduction
Specification
Section 1. General
1.1 Scope
1.2 Normative references
1.3 Definitions
1.4 Appearance
Section 2. Tubular polymeric film for site application
2.1 Composition
2.2 Additives and residuals
2.3 Reworked material
2.4 Film structure
2.5 Dimensions
2.6 Properties
2.7 Marking
2.8 Packaging, distribution and storage
Section 3. Sheet polymeric film for factory application
3.1 Composition
3.2 Additives and residuals
3.3 Reworked material
3.4 Film structure
3.5 Dimensions
3.6 Mechanical properties
3.7 Reel parameters
Section 4. Factory application of film to pipe
4.1 Adhesive
4.2 Application of hot melt adhesive to film
4.3 Adhesive joint type tests
4.4 Application of film to the pipe surface
4.5 Marking
Section 5. Certification
5.1 Manufacturer's certificate
Section 6. Repair of damaged sleeving before or during
installation of pipeline
6.1 General
6.2 Repair material
Tables
1 Layflat width of tubular polymeric film for
      various sizes of iron pipe
2 Required mechanical properties for the two types of
      site-applied sleeving
3 Required mechanical properties for the three types
      of factory-applied sleeving
Figures
1 Position of film on spigot end of pipe
2 Position of film on socket end of pipe
List of references

Specifies the composition, structure, mechanical properties, sizes, testing, marking and appearance requirements of both tubular film for site application and sheet polymeric film for factory application.

This British Standard specifies the composition, structure, mechanical properties, sizes, testing, marking and appearance requirements of both tubular polymeric film for site application and sheet polymeric film for factory application to ductile iron pipes. This British Standard also specifies requirements for the factory application of sheet sleeving and the repair of sleeving before or during installation of the pipeline.