BS 7291-2:2010
Withdrawn
A Withdrawn Standard is one, which is removed from sale, and its unique number can no longer be used. The Standard can be withdrawn and not replaced, or it can be withdrawn and replaced by a Standard with a different number.
Thermoplastics pipe and fitting systems for hot and cold water for domestic purposes and heating installations in buildings Specification for polybutylene (PB) pipe and associated fittings
Hardcopy , PDF
English
30-04-2010
28-04-2023
Foreword
1 Scope
2 Normative references
3 Materials
4 PB pipes
5 Fittings for PB pipes
6 Marking and associated information
Annexes
Annex A (normative) - Method of test for resistance to
thermal ageing
Annex B (normative) - Crystallization, transformation and
conditioning: Test procedure
Annex C (normative) - Method of test for resistance to
pull-out of assembled joints
Annex D (informative) - Guidance on factory control
procedures
Bibliography
Describes general requirements and methods of test for polybutylene (PB) pipe and fitting systems intended for use within buildings for the conveyance of cold water, including drinking water, and heated water for use in domestic hot and cold water distribution and heating installations.
| Committee |
PRI/88
|
| DevelopmentNote |
Supersedes BS 7291-2(2006) & 09/30208676 DC. (04/2010)
|
| DocumentType |
Standard
|
| Pages |
22
|
| PublisherName |
British Standards Institution
|
| Status |
Withdrawn
|
| Supersedes |
This part of BS7291 specifies general requirements and methods of test for polybutylene (PB) pipe and fitting systems intended for use within buildings for the conveyance of cold water, including drinking water, and heated water for use in domestic hot and cold water distribution and heating installations. These requirements supplement the general requirements in BS7291‑1, which are also applicable.
NOTE1 Before reading this part, it is essential to read BS7291‑1.
NOTE2 Methods of test are given in Annex A, Annex B and Annex C.
Annex D gives guidance on factory control procedures.
This standard specifies general requirements for materials to be used for, or in the form, of PB monolayer, multilayer or barrier pipes, and associated fittings and components. Particular requirements are also specified for PB pipe alone or jointed with push-fit, fusion or compression fittings conforming to BS7291 or other British Standards intended for use with pipes conforming to this part.
This part of BS7291 provides for pipes dimensioned to suit two established metric series: BSISO4065 for thermoplastics pipes generally and BSEN1057, for compatibility with copper pipework systems widely used for these applications.
This British Standard is applicable only to Class \'S\' pipes and fittings.
It does not specify dimensional requirements for fittings because the performance requirements specified for fittings, when tested individually or in assemblies with pipe, are intended to ensure that the dimensions of the fittings are satisfactory for jointing purposes and pressure containment.
NOTE3 Pipes and fittings of non-barrier PB are to some extent permeable to oxygen; hence, if they are used for the primary circuit(s) of a heating system, it might be beneficial to add a corrosion inhibitor to the fluids circulating therein. In such a case the manufacturer(s) of the pipe and/or fitting should, upon request, provide advice in accordance with BS5955‑8. This advice should include selection of a compatible corrosion inhibitor and/or methods for reducing the permeability.
This standard has been withdrawn and is no longer current. No replacement edition is available.