BS 7393:1990

Committees responsible
National foreword
Method
1 Scope
2 Normative references
3 Principle
4 Definition
5 Reagents and materials
6 Apparatus
7 Preparation of used oil samples
8 Procedure
9 Expression of results
10 Test report
Table
1 Size of sample
Figures
1 Schematic drawing of typical apparatus
2 Precision curves

Determination in new or used products or lubricants soluble or suspendable in mixtures of toluene or isopropanol. Determination on a sample too small to be accurately analysed by other methods when the acidity has a dissociation constant in water larger than 10$u-⁹.

1.1 This International Standard specifies a semi-micro colour indicator titration method for the determination of acidic constituents in new or used petroleum products and lubricants soluble in mixtures of toluene and isopropyl alcohol, or capable of existing as suspensions in such mixtures.

The method is especially intended for applications in which the amount of sample available to be analyzed is too small to allow accurate analysis by ISO 6619 or ISO 6618. It is applicable to the determination of acids having dissociation constants in water larger than 10^-9. Extremely weak acids having dissociation constants smaller than 10^-9 do not interfere. Salts titrate if their hydrolysis constants are larger than 10^-9.

1.2 This method may be used to indicate relative changes in total acid number that occur in an oil during use under oxidizing conditions. Although the titration is made under definite equilibrium conditions, the method does not measure an absolute acidic property that can be used to predict performance of an oil under service conditions. No general relationship between bearing corrosion and acid number is known.

1.3 Since this test method requires substantially less sample than ISO 6618 or ISO 6619, it provides an advantageous means of monitoring an oxidation test by changes in total acid number by

1. minimizing test sample depletion for total acid number analyses and thus minimizing the disturbance of the test or
2. allowing additional total acid number analyses to be made while maintaining the same test sample depletion and thus providing additional data.

NOTE 1 Some oils, such as many cutting oils, rustproofing oils, and similar compounded oils, or excessively dark-coloured oils, may be more difficult to analyze by this method due to obscurity of the colour indicator end-point. These oils can be analyzed by ISO 6619 provided sufficient sample is available. However, this situation is much less likely using this International Standard than using ISO 6618, due to the use of a more highly dilute sample during the titration and due to the greater stability of the end-point colour change. The acid numbers obtained by this method may or may not be numerically the same as those obtained by ISO 6619, but they should be of the same order of magnitude.

NOTE 2 The results obtained using this method have been found to be numerically the same as those obtained using ISO 6618, within the precision of the two methods, for new or oxidized lubricants of the type primarily intended for hydraulic or steam turbine type service. The oxidized lubricants were obtained using ISO 4263.

This correlation is shown by the correlation coefficient r = 0,989, with slope s = 1,017 and intercept y = + 0,029, calculated using the total acid numbers obtained using both titration methods for the samples used for the precision statement (see 9.2).