BS 919-2:2007
Current
The latest, up-to-date edition.
Screw gauge limits and tolerances Specification for gauges for screw threads of Whitworth and B.A. forms
Hardcopy , PDF
English
30-09-2009
Foreword
1 Scope
2 Normative references
3 Terms and definitions and symbols
4 Design
5 Disposition of gauge tolerance zones
6 Gauges for internal screw threads
7 Gauges for external screw threads and
their setting plugs
8 Marking
Annexes
Annex A (informative) - Function and method of
use of various gauge types
Annex B (informative) - Conventional illustration
of tolerance zones
Annex C (informative) - Effective diameter equivalent
of pitch and angle errors
Annex D (normative) - Thread form of NOT GO effective
diameter gauges
Annex E (informative) - Hardness
Bibliography
Describes requirements for the following gauges intended for checking screw threads in the regular series, such as BS Whit., BS Fine, B.A., BSC and BS Conduit.
Committee |
FME/9
|
DevelopmentNote |
Supersedes BS 919-2(1971) & 07/30158515 DC. (11/2007) Reviewed and confirmed by BSI, October 2012. (09/2012)
|
DocumentType |
Standard
|
Pages |
42
|
PublisherName |
British Standards Institution
|
Status |
Current
|
This Part of BS 919 specifies requirements for the following gauges intended for checking screw threads in the regular series, such as BS Whit., BS Fine, B.A., BSC and BS Conduit.
a) Screw gauges for general and reference use:
- solid (non-adjustable) screw plug gauges, GO and NOT GO;
- solid and adjustable GO screw ring gauges;
- adjustable thread calliper gauges, GO and NOT GO.
NOTE NOT GO effective diameter ring gauges are also included since they have certain limited applications. In principle, however, their use is not recommended.
b) Plain plug gauges and plain calliper gauges for the crests of threads.
NOTE Provision is made in the standard for both GO and NOT GO plain gauges, but GO plain gauges are normally required only in the case of threads where the corresponding GO screw gauges do not control the maximum metal condition at the crests of the threads of the product.
c) Setting plugs for adjustable screw ring and thread calliper gauges, GO and NOT GO.
This standard may be applied also to gauges for any screw threads of Whitworth form, but not to gauges for Acme, buttress or round threads.
Annex A provides guidance on the various types of gauges.
Information relating to the effective diameter equivalent of pitch and angle errors and to the thread form of NOT GO effective diameter gauges is given in Annex B, Annex C and Annex D.
No requirements are specified for the materials for gauges, but guidance on the hardness of gauges is given in Annex E.
BS 6528:1984 | Glossary of terms for cylindrical screw threads |
BS 811:1950 | Specification for cycle (B.S.C.) threads (formerly known as C.E.I. threads) |
BS 1044-1:1964 | Specificaton for gauge blanks Plug, ring and calliper gauges |
BS 84:2007 | Parallel screw threads of Whitworth form. Requirements |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.