BS 9940-04.0:1984

National foreword
Committees responsible
Section One - General
1. General
1.1 Scope
1.2 Object
1.3 Related documents
1.4 Information to be given in a detail specification
1.5 Marking
Section Two - Preferred ratings, characteristics and
test severities
2. Preferred ratings, characteristics and test
      severities
2.1 Preferred characteristics
2.2 Preferred values of ratings
2.3 Preferred test severities
Section Three - Quality assessment procedures
3. Quality assessment procedures
3.1 Structurally similar components
3.2 Qualification approval
3.3 Quality conformance inspection
Appendix A. Standardized schematic diagrams and pin
             identifications for fixed resistor networks
A1. Diagrams for "Single-In-Line" configurations
A2. Diagrams for "Dual-In-Line" and "Flat Pack"
     configurations

Prescribes ratings and characteristics and selects QA procedures, tests and measuring methods for this type of network in which the resistive elements may be individually insulated or interconnected in any configuration which permits the measurement of each individual resistor.

This standard applies to fixed resistor networks in which each individual resistor can be measured. The resistors may be individually isolated or interconnected in any circuit configuration which permits the measurement of each individual resistor.

NOTE A separate sectional specification covering complex networks will be published as IEC Publication 115-7 (under consideration).