BS AU50-2.7(1987) : 1987
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
TYRES AND WHEELS - WHEELS AND RIMS - CODE OF PRACTICE FOR THE SELECTION AND CARE OF WHEELS FOR COMMERCIAL VEHICLES
Hardcopy , PDF
15-12-1995
English
01-01-1987
Foreword
Committees responsible
Code of practice
7.1 Scope
7.2 Tyre and rim selection
7.3 Wheel selection
7.4 Types of flanges and locking rings
7.5 Removing and fitting tyres
7.6 Wheel checks
7.7 Wheel mounting checks
7.8 Securing the wheel to the vehicle
7.9 In-service wheel checks
7.10 Removing wheel from vehicle
7.11 Check list for commercial vehicle wheel care
Appendices
A. Types of rims and wheels
B. Types of flanges, spring flanges and locking rings
Figures
1. Wheel fixings
2. Sequence of stud tightening
3. Wide base rims
4. Flat base rims
5. Semi drop centre (SDC) rims
6. 15 deg drop centre rims
7. 5 deg well base rim
8. Divided rim
9. Single wheel offset
10. Dual (twin) wheel, offset or half dual spacing
11. Typical flanges and locking rings
Provides recommendations for vehicle manufacturers on the steps to be taken in selecting wheels for commercial vehicles and recommends on the care of wheels for the user. Covers tyre and rim selection, wheel selection, types of flanges and locking rings, removing and fitting tyres, wheel checks, wheel mounting checks, securing the wheel to the vehicle, in-service wheel checks, removing wheel from vehicle and check list for commercial vehicle wheel care.
Committee |
AUE/4
|
DevelopmentNote |
BS DRAFT 95/701902 DC
|
DocumentType |
Standard
|
Pages |
18
|
PublisherName |
British Standards Institution
|
Status |
Superseded
|
SupersededBy |
BS AU50-1.2G(1990) : 1990 | TYRES AND WHEELS - TYRES - SPECIFICATION FOR SIZES, LOADS, INFLATION PRESSURE AND RIMS FOR COMMERCIAL VEHICLE TYRES |
BS AU 50-2.3:1994 | Tyres and wheels. Wheels and rims Specification for road-wheel nuts, studs and bolts for commercial vehicles |
BS AU50-2(1984) : 1984 AMD 8586 | SPECIFICATION FOR DIMENSIONS OF WHEEL NAVES AND HUB CENTRES FOR COMMERCIAL VEHICLES. |
BS AU50-2.0(1979) : AMD 8365 | GENERAL (INCLUDING TERMS & DEFINITIONS & CONSTRUCTION & WORKMANSHIP) |
BS AU50-2.1B(1980) : 1980 | RIM PROFILES & DIMENSIONS (INCLUDING OPENINGS FOR VALVES) |
BS AU50-1.2E(1986) : LATEST | TYRES AND WHEELS - TYRES - COMMERCIAL VEHICLE TYRES |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.