BS EN 10341:2006

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Classification and designation
   4.1 Classification
   4.2 Designation
5 Information to be supplied by the purchaser
   5.1 Mandatory information
   5.2 Options
6 General requirements
   6.1 Production process
   6.2 Form of supply
   6.3 Delivery condition
   6.4 Surface condition
   6.5 Suitability for cutting
7 Technical requirements
   7.1 Magnetic properties
   7.2 Geometrical characteristics and tolerances
   7.3 Other properties
8 Inspection and testing
   8.1 General
   8.2 Sampling
   8.3 Preparation of test specimens
   8.4 Test methods
   8.5 Retests
9 Marking, labelling and packing
10 Complaints
Annex A (informative) Maximum specific total loss at 1,0 T
Annex B (informative) Density determination
Bibliography

Defines cold-rolled electrical non-oriented non-alloy) or alloy) steel sheet and strip delivered in nominal thicknesses of 0,50 mm and 0,65 mm in the semi-processed condition, that is without final heat treatment; in particular, it also describes general requirements, magnetic properties, geometric characteristics and tolerances and technological characteristics, as well as the inspection procedure.

This document specifies cold-rolled electrical non-oriented non-alloy ) or alloy ) steel sheet and strip delivered in nominal thicknesses of 0,50 mm and 0,65 mm in the semi-processed condition, that is without final heat treatment; in particular, it specifies general requirements, magnetic properties, geometric characteristics and tolerances and technological characteristics, as well as the inspection procedure. This document applies to material intended for the construction of magnetic circuits. These magnetic materials correspond respectively to subclauses C21 and B2 of IEC 60404-1:2000.