BS EN 12186:2014

Foreword
1 Scope
2 Normative references
3 Terms, definitions, symbols and abbreviations
4 Quality and management system
5 Environmental impact
6 Layout of the gas pressure regulating station
7 Housings
8 Design of the station
9 Pressure control
10 Testing
11 Commissioning
12 Operation and maintenance
13 Decommissioning and disposal
Annex A (informative) - Glossary
Annex B (informative) - Significant technical changes between this
        European Standard and the previous edition
Bibliography

Describes the relevant functional requirements for gas pressure regulating stations, which form part of gas transmission or distribution systems.

This European Standard contains the relevant functional requirements for gas pressure regulating stations, which form part of gas transmission or distribution systems. It is applicable to the design, materials, construction, testing, operation and maintenance of gas pressure regulating stations. This European Standard does not apply to gas pressure regulating stations commissioned prior to the publication of this standard. The stations covered by this European Standard have a maximum upstream operating pressure which does not exceed 100 bar. For higher maximum upstream operating pressures this standard should be used as a guideline. If the inlet pipework of the station is a service line and the maximum upstream operating pressure does not exceed 16 bar and the design flow rate is equal to or less than 200m 3/h under normal conditions, EN12279 applies. Basic system requirements for gas pressure regulating stations are contained in this European Standard. Requirements for individual components (valves, regulators, safety devices, pipes, etc.) or installation of the components are contained in the appropriate European Standards. NOTE For combined regulating and measuring stations, the additional requirements of EN1776 can apply. The requirements in this European Standard do not apply to the design and construction of auxiliary facilities such as sampling, calorimetering, odorization systems and density measuring. These facilities are covered by the appropriate European Standards, where existing, or other relevant standards. The requirements of this European Standard are based on good gas engineering practice under conditions normally encountered in the gas industry. Requirements for unusual conditions cannot be specifically provided for, nor are all engineering and construction details prescribed. The requirements in this European Standard are based on the physical and chemical data of gaseous fuels - including non-conventional gases - in accordance with Table1 of EN437:2003+A1:2009 for first and second family gases. Additional requirements in the case of gaseous fuels heavier than air and/or sour gases are not covered by this European Standard. The objective of this European Standard is to ensure the safe operation of such stations. This does not, however, relieve all concerned of the responsibility for taking the necessary care and applying effective quality management during the design, construction and operation.