BS EN 13043:2013

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements for coarse and fine aggregate
5 Requirements for filler aggregate
6 Evaluation of conformity
7 Designation
8 Marking and labelling
Annex A (informative) - Notes for guidance on the
        freezing and thawing resistance of aggregates
Annex B (normative) - Factory production control
Annex ZA (informative) - Clauses of this European
         Standard addressing essential requirements
         or other provisions of EU Directives
Bibliography

Describes the properties of aggregates and filler aggregates obtained by processing natural, manufactured or recycled materials and mixtures of these aggregates for use in bituminous mixtures and surface treatments for roads, airfields and other trafficked areas.

This European Standard specifies the properties of aggregates and filler aggregates obtained by processing natural, manufactured or recycled materials and mixtures of these aggregates for use in bituminous mixtures and surface treatments for roads, airfields and other trafficked areas. This standard does not cover the use of reclaimed bituminous mixtures3 . It also covers recycled aggregate with densities between 1,50 Mg/m3 (1 500 kg/m3) and 2,00 Mg/m3 (2 000 kg/m3) with appropriate caveats and recycled fine aggregate with appropriate caveats.

A list of the source materials that have been considered and indicating those which are within the scope of this standard is given in Annex A (normative).

Requirements for the evaluation of conformity of the products to this European Standard are given in EN 16236.

It incorporates a general requirement that aggregates shall not release any dangerous substances in excess of the maximum permitted levels specified in a relevant European Standard for the material or permitted in the national regulations of the member state of destination.

The tables in this standard include categories which are common across the four main aggregate standards: EN 12620, EN 13043, EN 13139 and EN 13242. Not all of these categories are appropriate for aggregates for use for bituminous mixtures.

Categories, notes, comments etc., which are grey shaded, should not be used for aggregates for bituminous mixtures.

Aggregates used in construction should comply with all the requirements of the relevant European Standards. These standards include comprehensive and specific requirements for natural aggregates, iron and steel making slag and recycled aggregates, dealing with, for example, the stability of certain basalts, the expansion of certain slags and the constitution of recycled aggregates.

For materials from some other secondary sources, however, work is ongoing and the requirements are incomplete. In the meantime, such materials, when placed on the market as aggregates, should conform fully to this standard but may also be required to conform to specific relevant additional requirements at the place of use. Additional characteristics and requirements may be specified on a case by case basis depending upon experience of use of the product, and defined in specific contractual documents.

NOTE 1 Requirements for lightweight aggregates are specified in EN 13055. Requirements for the declaration of the potential of aggregates to release regulated dangerous substances are currently under development. Until such time as these are finalised, attention should be paid to requirements at the place of use.

NOTE 2 Requirements for reclaimed asphalt for use as a constituent of asphalt mixtures are specified in EN 13108-8 and are not therefore covered in detail in this standard. EN 13108-8 does however call up the general requirements of EN 13043 for the aggregate component of reclaimed asphalt.