BS EN 1386:2007

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Pattern types
5 Selection of materials
6 Order information
7 Requirements
   7.1 General
   7.2 Technical conditions for inspection and delivery
   7.3 Surface conditions
   7.4 Mechanical properties
   7.5 Bend test
   7.6 Exfoliation corrosion resistance and intergranular
        corrosion (5xxx series alloys)
   7.7 Tolerances on dimensions and form
   7.8 Straightness of the longitudinal edge
   7.9 Flatness
   7.10 Squareness
8 Inspection and test procedures
   8.1 Inspections and tests to be carried out
   8.2 Type and content of inspection documents
9 Quality assurance
10 Marking and/or labelling
11 Arbitration
Annex A (normative) Rules for rounding
Annex B (informative) Explanation of temper designation used
        in Table 1 based on definitions of EN 515
Bibliography

Defines the technical conditions of inspection and delivery, the mechanical properties, the tolerances on dimensions and form of rolled semi-finished aluminium alloy products intended for floor plating, e.g. in vehicle construction, shipbuilding and metallic structures with a raised pattern on one side and a smooth surface on the other side.

This document specifies the technical conditions of inspection and delivery, the mechanical properties, the tolerances on dimensions and form of rolled semi-finished aluminium alloy products intended for floor plating, e.g. in vehicle construction, shipbuilding and metallic structures with a raised pattern on one side and a smooth surface on the other side. It applies to sheets, strips and plates from 1,2 mm up to 20 mm in thickness and up to and including 2 500 mm in width, and to sheets and plates up to 14 000 mm in length.