BS EN 1514-6:2003

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Designations
  4.1 Range of PN designations
  4.2 Range of DN (nominal sizes)
  4.3 Gasket types
  4.4 Information to be supplied by the purchaser
5 Constructional details
  5.1 General details
  5.2 Core
      5.2.1 Core materials
      5.2.2 Core welding
      5.2.3 Dressing of core welds
      5.2.4 Core flatness
  5.3 Serrations
  5.4 Location rings
      5.4.1 Integral ring
      5.4.2 Loose ring
  5.5 Facing materials
  5.6 Facing weight per unit area
  5.7 Attachment of facing
      5.7.1 Methods of attachment
      5.7.2 De-greasing of core
      5.7.3 Number of joins
      5.7.4 Excessive facing
  5.8 Integrity of facing attachment
  5.9 Typical construction details
6 Dimensions
7 Marking
8 Colour coding
9 Packaging
Annex A (informative) Information to be supplied by the
                      purchaser

Describes the construction, dimensions and marking of covered serrated metal gaskets for use with flanges complying with EN 1092-1 for PN 10, PN 16, PN 25, PN 40, PN 63 and PN 100 up to and including DN 3000.

This European Standard specifies the construction, dimensions and marking of covered serrated metal gaskets for use with flanges complying with EN 1092-1 for PN 10, PN 16, PN 25, PN 40, PN 63 and PN 100 up to and including DN 3000. This document does not extend to covered serrated metal based heat exchanger gaskets with pass bars or large vessel gaskets but, in the lack of a dedicated document for such gaskets, the principles set down can be applied to them. NOTE 1 Dimensions of other types of gaskets for use with flanges to EN 1092-1, EN 1092-2, prEN 1092-3 and EN 1092-4 are given in EN 1514-1, EN 1514-2, EN 1514-3, EN 1514-4, prEN 1514-7 and prEN 1514-8. NOTE 2 Annex A lists information that should be supplied by the purchaser when ordering gaskets in circumstances where the choice of the gasket materials appropriate to the service is left to the supplier.