BS EN 16753:2016

European foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Operational principles
5 NDE personnel qualification
6 Marking
7 Certification/Report
8 Rendering tubes unserviceable
Annex A (normative) - Description, evaluation of
        defects and conditions for rejection of refillable
        seamless steel pressure vessels (tubes) at the
        time of visual inspection
Annex B (informative) - Procedure for the examination of
        refillable seamless steel pressure vessels (tubes)
        using acoustic emission (AE) techniques
Annex C (informative) - Recommended time intervals for
        certain commonly contained gases
Annex D (informative) - Pre-inspection site survey
        checklist/questionnaire
Bibliography

Defines requirements for using a combination of appropriate in situ (without dismantling), non-destructive examination (NDE) techniques, for example visual examination, acoustic emission testing [AT] and ultrasonic testing [UT] when periodically inspecting and testing seamless steel pressure vessels (tubes) with a water capacity between 150 l and 3 000 l, used for compressed and liquefied gases for a further period of service.

This European Standard specifies requirements for using a combination of appropriate in situ (without dismantling), non-destructive examination (NDE) techniques, for example visual examination, acoustic emission testing [AT] and ultrasonic testing [UT] when periodically inspecting and testing seamless steel pressure vessels (tubes) with a water capacity between 150l and 3000l, used for compressed and liquefied gases for a further period of service.

This European Standard is applicable only to pressure vessels (tubes) installed in locations where attempting any removal from their containing superstructure would be hazardous, or where the downtime required to remove them would hinder a continuous operation of a plant or service.

This European Standard does not apply to pressure receptacles used for the transport of gases as described under the TPED.

This European Standard only applies to pressure vessel (tube) assemblies where the designs permit all necessary inspections stipulated.