BS EN 1982:2017

European foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Designations
5 Ordering information
6 Requirements
7 Sampling and testing frequency
8 Test methods
9 Declaration of conformity and inspection documentation
10 Marking, labelling, packaging
Annex A (informative) - Guidance for the ordering and supply
        of copper and copper alloy castings
Annex B (informative) - Optional supplementary testing
        procedures for ingots and castings
Annex C (normative) - Unalloyed copper
Annex D (normative) - Copper-chromium alloys
Annex E (normative) - Copper-zinc alloys
Annex F (normative) - Copper-zinc-aluminium alloys
Annex G (normative) - Copper-zinc-lead alloys
Annex H (normative) - Copper-zinc-silicon alloys
Annex I (normative) - Other copper-zinc alloys
Annex J (normative) - Copper-tin alloys
Annex K (normative) - Copper-tin-zinc-lead alloys
Annex L (normative) - Copper-tin-lead alloys
Annex M (normative) - Copper-aluminium alloys
Annex N (normative) - Copper-manganese alloys
Annex O (normative) - Copper-nickel alloys
Annex P (normative) - Copper-silicon-zinc alloys
Annex ZA (informative) - Relationship between this European
          Standard and the Essential Safety Requirements
          of Directive 2014/68/EU aimed to be covered
Bibliography

Defines the composition, mechanical properties and other relevant characteristics of copper and copper alloys.

This European Standard specifies the composition, mechanical properties and other relevant characteristics of copper and copper alloys. The sampling procedures and test methods for the verification of conformity to the requirements of this standard are also specified. This European Standard is applicable to: a) copper alloy ingots intended to be remelted for later processing (e.g. castings); and b) copper and copper alloy castings which are intended for use without subsequent working other than machining. Recommended practice for the ordering and supply of castings is included in Annex A. Optional supplementary inspection procedures for ingots and castings are included in Annex B. NOTE Ingots are not suitable for pressure equipment applications.