BS EN 50665:2017

European foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Exposure conditions
5 Normative limits
6 Evaluation of compliance
7 Assessment uncertainty
8 Evaluation report
Annex A (informative) - Harmonized product
        standards
Annex ZZA (informative) - Relationship between
          this European standard and the safety
          objectives of Directive 2014/35/EU [2014
          OJ L96] aimed to be covered
Annex ZZB (informative) - Relationship between
          this European standard and the essential
          requirements of Directive 2014/53/EU [2014
          OJ L153] aimed to be covered

Describes a route for evaluation of such equipment against limits on human exposure to electric, magnetic and electromagnetic fields, and induced and contact current.

This European Standard applies to electronic and electrical equipment for which no dedicated harmonized product- or product family standard, or standard relating to low power equipment, regarding human exposure to electromagnetic fields exists. If such a standard does exist then it shall be used and this standard shall not. AnnexA lists such harmonized standards available at the time of writing This list may change with time. The current list of standards harmonized under each Directive should be consulted at the time of use of this standard. The object of this generic standard is to provide a route for evaluation of such equipment against limits on human exposure to electric, magnetic and electromagnetic fields, and induced and contact current. The frequency range covered is 0Hz to 300GHz. This standard is intended to cover both intentional and non-intentional radiators. NOTE1 Other standards can apply to products covered by this document. In particular, this document is not designed to evaluate the electromagnetic compatibility with other equipment; nor does it reflect any product safety requirements other than those specifically related to human exposure to electromagnetic fields. NOTE2 This standard addresses only human exposure from the specific equipment under evaluation. There is an applicable putting-into service/ in situ standard for equipment used by workers when at work: EN50664:2017 . Generic standard to demonstrate the compliance of equipment intended for use only by workers with limits on human exposure to electromagnetic fields (0Hz - 300GHz), when put into service or in situ.