BS EN 55016-1-6 : 2015

1 Scope
2 Normative references
3 Terms, definitions and abbreviations
4 Fundamental concepts
5 Calibration methods for the frequency
  range 9 kHz to 30 MHz
6 Frequencies, equipment and functional
  checks for calibrations at or above 30 MHz
7 Basic parameters and equations common
  to antenna calibration methods for frequencies
  above 30 MHz
8 Details for TAM, SAM, and SSM calibration
  methods for frequencies of 30 MHz and above
9 Calibration procedures for specific antenna
  types for frequencies of 30 MHz and above
Annex A (informative) - Background information
        and rationale for the methods of antenna
        calibration
Annex B (normative) - Calibration of biconical
        antennas and tuned dipole antennas above
        a ground plane using the TAM and the SAM
Annex C (informative) - Rationale for the equations
        used in antenna calibration and relevant
        information about antenna characteristics for
        uncertainty analysis in the frequency range 30
        MHz to 1 GHz
Annex D (informative) - Background information
        and rationale for calibration of antennas at
        frequencies above 1 GHz
Annex E (informative) - Notes for measurement
        uncertainty budgets
Annex F (informative) - Mismatch uncertainties
        from a two-port device connected between a
        transmit port and a receive port
Annex G (informative) - Verification method for
        calibration of monopole antennas and uncertainty
        analysis of the ECSM
Annex H (informative) - Helmholtz coil method for
        calibration of loop antennas up to 150 kHz
Bibliography
Annex ZA (normative) - Normative references to
         international publications with their
         corresponding European publications

Gives procedures and supporting information for the calibration of antennas for determining antenna factors (AF) that are applicable to antennas intended for use in radiated disturbance measurements.